Home > Engine Blocks >

ATK 13G2 Machined LM7 5.3L Bare Block 3.903" Bore
ATK 13G2 Machined LM7 5.3L Bare Block 3.903" Bore


 
Alternative Views:
List Price: $750.00
Our Price (USD): $750.00
Prop65 Warning This product can expose you to chemicals which are known to the state of California to cause cancer and birth defects or other reproductive harm.
For more information go to: www.P65Warnings.ca.gov


Availability:: Usually Ships in 24 Hours
Qty:

Description
 
ATK's Machined GM LM7/5.3L Bare Block is a great foundation to start building a new engine. This block comes fully machined in the popular 3.903" Bore size to make an Iron LS1/LS6 and is ready to build off!

Block: GM Seasoned LM7 / 5.3L 1999-2007
Bore: Size: 3.903"
Rear Seal: 1pc
Main Caps: 6 Bolt Main
Cam Bearings: Installed
Finished Bore: Yes (Piston size vary, final hone may be needed)
Camshaft: OE Hydraulic Roller

*Can be used in place of LS1/LS6 car applications, but the accessory hole on the Driver Side for the bracket will have to be drilled and tapped. ATK does NOT offer this service.

Notes: Due to the vast selection of parts,styles/sizing of Pistons & Connecting Rods ALL clearances should be checked before final assembly. Final hone and additional connecting rod clearance may be needed.
Features & Benefits
    • Magnafluxed
    • Line Honed
    • Bored to 3.903"
    • Torque Plate Honed
    • Decked (not zero) just a clean up
    • Lifter Bores Honed
    • Cam Bearings Installed
    • Galley Plugs Installed

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 1 Write a review »

  0 of 0 people found the following review helpful:
 
5 of 5 5 Stars! March 5, 2019
Reviewer: Roger Kellum from Burlison, TN United States  
Great product and price shipping was fast would order from again

Was this review helpful to you?